© MuxLab Inc.
2.
The Digital Audio Balun works in pairs. Plug one balun into the digital audio
output (coaxial) of the digital audio source.
3.
Plug a second balun into the digital audio input (coaxial) of the digital audio
decoder/amplifier at the remote end.
4.
Complete the connection between the two baluns, using standard twisted pair
cabling techniques as shown below.
DA Decoder/Amp
DVD or VCR
Digital Audio Source
Digital Audio
Decoder/Amplifier
Digital Audio Balun (500020)
1-pair twisted pair
5.
Power-on the digital audio equipment. Check to ensure that all audio channels
are being received.
Troubleshooting
The following table describes some of the symptoms, probable causes and possible
solutions in respect to the installation of the Digital Audio Balun. If you still
cannot diagnose the problem, please call MuxLab Customer Technical Support at
877-689-5228 (toll-free in N.Am) or 514-905-0588 (Intl).
Symptom
Probable Causes
Possible Solutions
No audio
EMI interference.
Check that wiring is not too close to
transformers and ballasts.
No audio
Distance exceeded
Verify cable length between the two
baluns.
No audio
Split pair
Check if the UTP pairs are split
and correct. Each signal pair must
be twisted.
No audio
Power-off.
Check power supplies of digital
audio equipment.
Missing channels
Cabling problem
between the
decoder/amp and the
audio speakers.
Check audio speaker cabling.
Intermittent static
noise on one or
more channels.
Distance exceeded or
unusual cable
attenuation
Check cable distance and cable
grade.
Specifications
Environment
Dolby® Digital, Dolby Pro Logic, dts®, LOGIC7®,
THX Surround EX™
Devices
DVD, VCR, Camcorders, satellite receivers, home theatre,
channel processors, amplifiers, D/A converters, MPEG
encoders/decoders, switchers and other commercial or
consumer audio equipment supporting digital audio.
Transmission
Transparent to the user.
Bandwidth
DC to 25 MHz
Maximum Input
1.0 Vp-p
Insertion Loss
Less than 1 dB per pair over the frequency range
Return Loss
Greater than 15 dB over the frequency range
Common Mode Rejection
Greater than 60 dB @ 10 MHz
Max. Distance (UTP)
Category 5 unshielded twisted pair – 600 ft. (183m)
Cable – UTP
24 gauge or lower solid copper twisted pair wire
impedance: 100 ohms at 1 MHz
Maximum capacitance: 20 pf/foot.
Attenuation: 6.6 dB/1000 ft at 1 MHz
Connectors
Two (2) screw terminals
One (1) S/PDIF (RCA) gold-plated male connector
Pin Configuration
Tip-signal, Ring-GND
Impedance
Input: 75 ohms (RCA)
Output: 100 ohms (Screw Terminals).
Temperature
Operating: 0 to 55 C. Storage:-20 to 85 C. Humidity: up
to 95%
Enclosure
Fire retardant plastic
Dimensions
2.30” x 0.62” x 0.62” (5.8 x 1.6 x 1.6 cm)
Weight
1.5 oz (42.5 gms)
Warranty
Lifetime
Order Information
500020 VideoEase Digital Audio Balun
