© MuxLab Inc. 2019
compliant cable.
3b
Connect the one (1) Cat 6a (or higher) grade UTP cable to the RJ45
LINK connector on the Receiver.
4.
This kit supports PoC, allowing the Transmitter to power the Receiver, or the
Receiver to power the Transmitter. Connect the 12VDC power supply to either the
Receiver or Transmitter first, and then plug the power supply into an AC power
outlet. If power is present, the blue power LED of the Transmitter and the Receiver
will be ON.
Note: Power the HDMI Extender only after all connections are made.
5.
Power the HDMI equipment and verify the image quality.
6.
Connect the IR Sensor to the 3.5mm Stereo Jack of the receiver and the IR
Emitter to the 3.5mm Mono Jack of the Transmitter.
Note: You can differentiate the IR Sensor and the IR Emitter by looking at the
3.5 mm plug. The IR Sensor is using a Stereo Plug (3 Contacts) and the IR
Emitter a mono plug (2 Contacts).
7.
Position the IR Sensor so that it is directed to the hand-held remote control. For a
clear IR signal reception, aim the hand-held remote control to the top of the IR
Sensor enclosure.
8.
Position the IR Emitter as close as possible to the source’s IR Sensor (i.e. DVD
player). For a clear IR signal reception, the IR Emitter can be glued on the source’s
IR Sensor. The IR Emitter’s signal is transmitted from the side of the enclosure.
9.
If infrared remote control is needed to control the Display equipment from the
Source, connect the IR Emitter to the 3.5mm Stereo Jack of the receiver and the IR
Sensor to the 3.5mm Mono Jack of the Transmitter.
10.
The following diagram shows the final configuration.
Troubleshooting
The following table describes some of the symptoms, probable causes and possible solutions
in respect to the installation of the HDMI Extender Kit:
Symptom
TX LED
RX LED
Probable
Cause
Possible
Solutions
Power/Link Power/Link
No Image
OFF
OFF
No power
• Check power connections
No Image
ON
ON
UTP or HDMI Cable
• Check the UTP Or HDMI
cables.
No Image
ON
ON
Synchronization
• Check cable length.
Flickering
Image
ON
ON
Synchronization
• Check cable length
• Check the HDMI Cable
Quality.
Choppy sound
ON
ON
Synchronization
• Check cable length
• Check the HDMI Cable
Quality.
Green or pink
hue
ON
ON
DDC communication
• Cycle power of the HDMI
Extender.
• Check UTP cables and
replace.
Image flickers
when powering
up nearby
equipment
ON
ON
Interference
• Use STP cables
IR not
functioning
ON
ON
Interference from sunlight,
Fluorescent, Neon or Halogen lights
• Place the IR equipment
away for the interfering
light
IR not
functioning
ON
ON
Interference from RF radiation from
the TV
• Place the IR equipment
away for the RF radiation
If you still cannot diagnose the problem, please call MuxLab Customer Technical Support at
877-689-5228 (toll-free in North America) or (+1) 514-905-0588 (International).
