MUTOH VJ-1938TX, Руководство по эксплуатации

Страница: 73 / 148

Set 1: User Type 73
Steps
1.
Select "PF1: Initial Print".
•
"Feed Length: 250 mm" is displayed on Operation panel.
2.
After the initial adjustment printing, cut the media.
•
Measure the distance between the " " in the initial adjustment print using a ruler.
3.
Refer to Chapter 1 「
Media feed adjustment steps
」
P. 56
and select "PF2: Initial Change" on the operation panel.
4.
Press the [+] key or [ - ] key on Operation panel and enter the measured value in Step 2.
•
Press the [Enter] key to save the initial adjustment value.
5.
Press the [+] key or [ - ] key on Operation panel to select "PF3: Confirm Print".
•
"Feed Length: 250 mm" is displayed on Operation panel.
6.
After the confirmation adjustment printing, cut the media.
•
Measure the distance between the " " in the confirmation adjustment print using a ruler. Then, confirm
that the distance matches the feeding length when printing.
•
If the distance does not match the feeding length, follow the procedure from Step 1 to Step 5 and readjust.
•
If the distance matches the feeding length, proceed to Step 7.
** > 3: PF Adjust
Sets up various settings on the Media feed correction.
When the following defects are found in printing results, they may improve by
conducting a media feed correction.
• Images are overlapping.
• There are white lines in images.
Submenus
「
PF1: Initial Print
」
P. 74
「
PF2: Initial Change
」
P. 75
「
PF3: Confirm Print
」
P. 75
「
PF4: Micro Print
」
P. 76
「
PF5: Micro Change
」
P. 76
* *> 3 : PF Adjust >
PF1 : Initial Print
PF2 : Initial Change
PF3 : Confirm Print
PF4 : Micro Print
PF5 : Micro Change