MUTOH VJ-1938TX, Руководство по эксплуатации, Страница: 74 / 148

74 Set 1: User Type
7.
Refer to Chapter 1 「
Media feed adjustment steps
」
P. 56
and select "PF4: Micro Print" on the operation panel.
•
Check the pattern and micro change value.
•
In the pattern, look for a place that has least white lines or overlapping in images. The number printed below
the adequate pattern is the micro change value.
8.
Press the [+] key or [ - ] key on Operation panel to select "PF5: Micro Change".
•
Press the [+] key or [ - ] key and enter the micro adjustment value according to the printing result in Step 7.
When you know the adjustment value (when changing the media or for similar operations)
1.
Enter the adjustment value for "PF5: Micro Change".
2.
Select whether you wish to print a confirm pattern and complete the setup.
PF1: Initial Print
• After the initial adjustment printing, cut the media.
• With a ruler, measure the length between “ ” in the pattern.
In the example below, the measured place is shown in orange dotted lines and arrows (the orange parts are not actually
printed).
Pressing the [Enter] key when the words on the left are displayed will execute initial
adjustment printing.
Setting values
100 mm to <250 mm> to 500 mm
<> indicates the initial value.
Note
The length of media that is fed (feeding length) for initial adjustment printing is normally set at 250 mm.
If you increase the feeding length, the accuracy of the Media feed adjustment improves.
To change the feeding length, press the [+] key or [ - ] key on Operation panel and change the set value.
PF1 : Initial Print
Feed Length : 250 mm