MAINTENANCE MANUAL
VC2E-MM-00
56
Media shifts away when plotting a long drawing.
[Check item]
[Action]
Is the media aligned accurately?
Reload the media.
Is the media pre-run with Jog key?
Reload the media and pre-run.
Is the media edge cut straightly?
Change the media.
Is the media too thin?
Change the media.
Is there any paper chips or dust on the drum?
Clean the surface of drum.
Is the drum or pinch roller worn?
Replace the drum set or pinch roller.
The cutting line is wavy.
[Check item]
[Action]
Is the screw on holder loose?
Tighten the screw firmly.
Is the blade worn?
Replace the blade.
Is the acceleration set too high?
Set the acceleration to a lower value.
Is the carriage belt tension correct?
Adjust the belt tension.
Is X or Y motor belt tension correct?
Adjust the belt tension.
Is the carriage bearing or roller damaged?
Replace the carriage.
Is the media length too short in X direction?
Change the media.
Is the media too thin?
Change the media.
Is the drum or pinch roller worn?
Replace the drum set or pinch roller.
Is X or Y motors damaged?
Replace the motor.
Data are missing when plotting.
[Check item]
[Action]
The memory chip may have a problem.
Replace the main board.
Serious error occurs when feeding media.
[Check item]
[Action]
Are some media pulled out from the roll?
Enable “Auto media feed” on the panel.
Is X motor belt too tight?
Adjust the belt tension.
Содержание ValueCut VC2-1300
