� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �
��
�
� � � � � � � � � � � � � �
� � � � � � � � � � � � � �
� � � � � � � � � � � � � �
� � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � �
��������������������������������������������
OPERATION
Functional Areas + Parameters
Your FORMAT CHANGER advanced provides four functional areas:
AUDIO INPUT
SYNC SOURCE
OUTPUT FREQUENCY
SCMS
Each of these functional areas comprises a variety of different parameters.
As an example, the illustration in the margin shows the functions included
in the functional area SYNC SOURCE.
After initial power-up of the unit the following parameters are preset in
the four functional areas (LEDs light up permanently):
Functional area AUDIO INPUT
Default parameter: S/PDIF OPT
Functional area SYNC SOURCE
Default parameter: BYPASS
Functional area OUTPUT FREQUENCY
Default parameter: 44,100 Hz
Functional area SCMS
Default parameter: SCMS not placed
Operating the FORMAT CHANGER advanced
After initial power-up of the unit, the LEDs of the functions selected (see
above) in the three functional areas light up permanently. Press the DATA
or SELECT key to edit one of the preset functions. Subsequently, the LED of
the preset function in the first functional area starts flashing, which signals
that you can now select another function or functional area.
SELECT key
The SELECT key is used to select one of the three functional areas. After
selection of a different functional area, the LED of the last function
selected in this area starts flashing. When you quit a functional area by
pressing the SELECT key again, the LED of the last function selected lights
up permanently.
DATA key
The DATA key is used to select a function from a specific functional area.
Use the upper key to select the functions above the current position, and
the lower key to select the functions below that position. Once a function
has been selected, its LED starts flashing.
If you press neither the DATA nor SELECT key for about 4 seconds, the LED
of the last function selected lights up permanently. To select a function
you must re-initiate SELECT mode now by pressing the SELECT key again.
Subsequently, the LED of the last function selected starts flashing. Press the
SELECT key again to select a new functional area, or the DATA key to select
a new function.
Parameters in functional area
Functional area
Parameters inclu-
ded in functional
area
When you select a new function, the
FORMAT CHANGER advanced remains in
the current functional mode, until the LED
of the new function selected has stopped
flashing. No further confirmation (ENTER
command, etc.) is required.
13
Functional areas
