Mutable Instruments Marbles, Быстрый старт

Страница: 11 / 16

All channels follow the settings on the control panel.
X
2
follows the control panel, while X
1
and X
3
take opposite
values. For example, if STEPS is turned fully CW, X
1
and X
3
will be smooth while X
2
is quantized to the root note and its
octaves.
X
1
follows the control panel, X
3
reacts in the opposite di-
rection, and X
2
always stays in the middle (steppy, unbiased,
bell-curve).
N. External processing mode (>see the next section) .
5. STEPS, SPREAD and BIAS CV inputs.
6. External clock input. When patched, all three outputs
follow the same external clock, as opposed to being clocked
by the three outputs from the t section.
7. CV outputs.
Sampling external CVs with the X generator
Press the button [N] to enable the external processing
mode. In this mode, the module samples the voltage present
on the SPREAD CV input (5) whenever a random value is
needed for one of the X outputs. This allows the artist to
sample, loop, quantize, shuffle, or transpose external CVs.
Y
Generator
The Y generator, by default, is a smooth, full-range (-5V to
+5V), random source that is clocked at 1/16 the rate of X
2
.
These settings can be modified by holding the button [M]
and adjusting RATE (division factor relative to X
2
, from 1/64
to 1), SPREAD, BIAS and STEPS while the button is held. The
Y output is never affected by the DEJA VU section.