Mutable Instruments Blinds, Руководство пользователя

Страница: 1 / 4

Blinds requires a -12V / +12V power supply (2x5 pin connector). The red stripe of the ribbon cable (-12V
side) must be oriented on the same side as the “Red stripe” marking on the board. The module draws
70mA from the -12V rail and 70mA from the +12V rail.
Current consumption can reach 90mA on either rail depending on the color and brightness of the LEDs.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
This device meets the requirements of the following standards: EN55032, EN55103-2,
EN61000-3-2, EN61000-3-3, EN62311.
Blinds is a 4-channel voltage-controlled signal polarizer. Each channel consists of a polarizer circuit, also
known as a four-quadrant multiplier. This circuit acts like a VCA, except that a negative control voltage will
cause the output signal to be inverted, instead of being silenced. Blinds’ outputs are daisy-chained,
allowing adjacent groups of 2, 3, or all 4 channels, to be mixed together.
Mutable Instruments | Blinds
1 of 4