Musway D8v2, Руководство пользователя

Страница: 11 / 36

11
ENGLISH
POW ON SEL (POWER ON SELECTION)
The amplifier can be turned on/off by using the following methods:
SPK: Slide the switch into position SPK, if you want to turn on/off the amplifier through
the CH1 input channel of the high level speaker inputs and its Auto Turn-On function.
Refer to page 9 and section 6 for more details.
REM: Slide the switch into position REM, if you want to turn on/off the amplifier through
the REM and a turn-on signal from head unit/car stereo.
Refer to page 9 and section 6 for more details.
OPT IN
The amplifier accepts through its Optical input PCM stereo signals up to 96 kHz / 24 bit sampling fre-
quency rate. Multi-channel signals coming from audio/video sources (such as the audio tracks of a film
in DVD) can not be reproduced. Connect a fiber optic cable with a TOSLINK connector.
DRC
This input is suited for an external MUSWAY digital remote controller. Check the website “www.mus-
way.de” for more information or ask your car audio retailer.
8
10
9
SYSTEM CONFIGURATION
Before turning on the system, set the head-unit output level to a lower level (approximately
20% of its maximum excursion) to avoid damaging the speakers during calibration.
WARNING
In order to configure the inputs, amplified speaker outputs and pre-amplified power outputs, EQ and time
delays for the amplifier, it must be interfaced with the PC. When you get to this point you must already be
aware of what type of system you intend to set up. In order to avoid complications in preparation, make sure
the following points before you start:
• The type of signals that will be assigned to the inputs (e.g.: front left or center or subwoofer, etc.).
• The speakers in the system (e.g.: 3-way front or sub stereo or 2-way rear, etc.).
• If there are passive crossovers that manage groups of speakers (e.g.: 3-way systems with active
midrange).
• If you intend to use an external mono amplifier to drive a subwoofer.
• If you intend to use the amplified outputs of the amplifier bridged (BLT mode), thus increasing the power on
the output.
CLIP
This LED lights up red if one of the 8 high level inputs (CH1-8) is overdriven. The LED has no function
when an input signal is applied to the Optical input and the Bluetooth™ input. If this LED lights up
reduce the input sensitivity by using the regarding controller Input Sensitivity until the LED goes out.
11