GET READY TO START
Before assembly, use scissors to unwrap the parts from the packaging. DO NOT use a box cutter or
exacto-knife as you may cut into the mantel pieces inside the box and damage the finish. Check for the
hardware bag which is red and located inside the packaging taped to the top box. Be sure you DO
NOT discard any pieces.
For the easiest assembly, use a power Phillips-head screwdriver. DO NOT over tighten the screws.
Step 1
Locate the hearth and place it on the floor. Do not put it up against
the wall at this point in the assembly as you need to get in behind
the mantel to insert several screws.
Step 2
Locate the left leg of the mantel. Facing the front of the hearth, take the
left leg, positioning it so the holes in the blocks on the legs line up with
the screw holes in the hearth. Insert the 1” screws into the smaller
screw holes and tighten.
Step 3
Locate the right leg of the mantel. Facing the front of the hearth, take the right leg, positioning it so the
holes in the blocks on the legs line up with the screw holes in the hearth. Insert the 1” screws into the
smaller screw holes and tighten.
