5
2.3) BASIC INPUT LOADING SETTINGS
INPUT LOADING SWITCH
To set the Input Loading, there are two eight-position switches, one for each
channel, located on the rear panel. Refer to your cartridge owner’s manual to
determine proper Input Loading settings. The factory setting for Input
Loading is 50,000 Ohms.
Switch #1 controls capacitive loading, which is often used with moving-
magnet cartridges and has little effect on moving-coil cartridges. When using
a moving-coil cartridge, try both capacitive loading positions to determine
the effect. CAPACITIVE LOADING (SWITCH #1): OFF=200pF; ON=300pF.
Switches #2-8 control resistive loading, which is primarily used with lower-
output moving-coil cartridges. Most moving-magnet along with medium and
high-output moving-coil cartridges use approximately 50,000 Ohms. Low-
output moving-coil cartridges typically use 2000 Ohms or less. Check the
chart below and select the closest Input Loading value to the cartridge
manufacturer’s recommended value. Typically, a lower resistive setting
provides increased focus and tighter bass, while a higher setting provides
more openness. Use a non-metallic object to select the proper settings,
flipping the switch UP to activate the ON setting.
