A1 FBP
OPERATION
Issue 1: 20
th
May 2008
Selecting the
AUX/HT
input can also be achieved using
the remote handset, using the corresponding button (see
p. 9).
TAPE
To use the
TAPE
input, connect external source to the
TAPE
input (see p.7). Select
TAPE
input using the
source up/down buttons until
TAPE
is shown in the
display.
Selecting the
TAPE
input can also be achieved using
the corresponding button on the remote handset, (see p.
9).
USB
To use the USB input, connect computer USB output to
the USB socket (see p.7). Select
USB
input using the
source up/down buttons until
USB
is shown in the
display.
Selecting the
USB
input can also be achieved using the
corresponding button on the remote handset, (see p. 9).
Note: the USB legend will flash if no USB signal is
detected.
BALANCED INPUT 1/HT
To use the balanced input (1), connect source unit’s
balanced outputs to the LEFT and RIGHT balanced
inputs (1) (see p.7). Select balanced input 1 using the
source up/down buttons until
BAL1
is shown in the
display.
Selecting the
balanced input 1 can also be achieved
using the corresponding button on the remote handset,
(see p. 9).
To use the
BAL1
as a balanced
H
ome
T
heatre direct
input, move the
BAL/HT
switch to the
HT
position.
The display will then refer to the input as
HT BAL
.
Connect line level outputs from home theatre processor
to the
BAL1
input (see p.7). Volume control is now
only possible (for this input) on the external processor.
Please note connecting standard line signals to these
inputs in HT mode will cause very loud and damaging
signals into the speakers that cannot be controlled
through the volume control. Please ensure correct
AUX/HT switch position before using this input
BALANCED INPUT 2
To use the balanced input (2), connect source unit’s
balanced outputs to the LEFT and RIGHT balanced
inputs (2) (see p.7). Select balanced input 2 using the
source up/down buttons until
BAL2
is shown in the
display.
Selecting the
balanced input 2 can also be achieved
using the corresponding button on the remote handset,
(see p. 9).
RECORDING AND TAPE MONITOR
To record to tape, (or alternatively CD recorder, DAT,
minidisk or computer soundcard analogue input) connect
the tape out to the tape recorder line in. Press the input
selector button on the front panel or remote control. This
source will now be routed to the A1 FBP
TAPE
OUT
for recording by tape deck.
The recording can be directly monitored through the
loudspeakers by pressing the
TAPE MONITOR
button.
Press again to return back to the input being recorded.
On some 3 head tape decks there is an additional
tape/source switch which should be in the tape position
for this to work. If in doubt, please consult tape deck
operating manual.
Note - adjustment of the volume control has no effect on
the recording level.
BAL1
™™™™ 33
USB
™™™™ 33
TAPE
™™™™ 33
HT BAL
™™™™ 33
BAL2
™™™™ 33
Page 11
of
15
