f
o
6
e
g
a
P
Issue
1
11
Introduction
Congratulations on the purchase of the new M6
s
PRX power amplifier. Great attention has been paid to internal
layout, isolating each circuit section to prevent possible interaction.
The unit features two monoblock amplifiers with separate choke regulated supplies for the absolute best in
separation and imaging. Generously rated, they are enough to drive even the most demanding loudspeakers
with ease. Low distortion and very quiet they will deliver all music types exactly as the artist originally intended.
The resultant performance achieved by this unit is among the best in the world. It has excellent signal to noise
ratio, low distortion, wide bandwidth and dynamic range, with extraordinary resolution and fine detail.
Cleaning
Before cleaning the unit, switch off power at the mains switch and remove the mains plug from the wall socket.
Clean the cabinet and remote control unit using a moist cloth. Using solvents, white spirit or thinners is not
advised, as they could damage the surface finish.
Installation
Position the M6
s
PRX on a stable, horizontal surface where there is no risk of it being knocked, or subjected
to vibration such as from loudspeakers.
Important note:
In normal operation, the unit dissipates a small quantity of power at all times, and it is important
that it is adequately ventilated. The top and bottom are perforated to allow the smooth flow of heat
through the unit. It is therefore not recommended that the unit is enclosed in a cabinet or placed
where the ventilation holes are impeded as this could result in excessive heat build-up.
The M6
s
PRX must be protected from humidity – if the unit is moved from a cold place to a
warm room, leave the unit for an hour or so to allow sufficient time for the moisture to evaporate.
Power Connections
The M6
s
PRX is supplied with a standard IEC mains cable which plugs into the IEC socket at the back of the
unit (see page 7)
Audio Connections
RCA Inputs:
Connect all RCA single-ended sources to relevant analogue inputs (see page 7 for more
information). Use good quality fully connected (signal and ground) coaxial phono cables for all RCA signal
connections. 2 inputs
INPUT A
and
INPUT B
are provided to enable the amplifier to be used with more than
one setup for example, A = home theatre, B = audio only.
XLR Inputs:
Connect any XLR balanced source to balanced analogue input (see page 7 for more information).
Use good quality fully connected (signals and ground) balanced XLR cables for all XLR signal connections.
Outputs:
Connect loudspeakers to the terminals on the back panel marked as
LEFT
and
RIGHT SPEAKER
outputs
The
LOOP OUT
output allows the input signals to be passed on to a second amplifier or other component. This
is useful for bi-amping.
INSTALLATION
