of the MUSICA logos on the grilles. Simply pull the logo out slightly and turn the logo 90 degrees,
where it will lock into place in the new direction.
PAINTING THE SPEAKERS:
The injection molded, polypropylene, talc impregnated cabinets can be painted to match your
decor. You should prime the cabinet with two coats of a product such as KrylonTM Sandable
Spray Primer #1318. You may use oil or water based house paint or spray paint. (Be sure to use
appropriate exterior house paint for outdoor applications).
1. Remove the grilles and brackets
2. Mask the speaker components and input terminals area with newspaper and masking tape.
3. Apply two thin primer coats to the speaker cabinets and knobs. (The brackets do not require
a primer coat.)
4. After the primer coats are completely dry, paint the cabinets, brackets and knobs. Be careful
not to paint the input terminals.
PAINTING THE GRILLES:
Remove and paint the grilles before inserting them onto the frames:
Using a paper clip bent into a “hook” shape, insert it into a grille near the corner and pull the
grille away from the cabinet.
Apply (2) thin coats of paint (primer is not required) be careful not to let the paint clog the
holes in the grilles.
CONNECTIONS:
The MUSICA52WRM input terminals are 5-way binding posts. The binding post is designed
to accept up to 14#AWG stranded cable or standard banana plugs.
Be sure to use a good quality, unshielded twisted pair speaker cable to connect the amplifier
to the speaker(s) (#16AWG for runs less than 80’, #14AWG for runs greater than 80’). Standard
ZIP style speaker cable may also be used if twisted pair cable is not available.
When making the connections, be sure to maintain proper polarity between speakers. (Red
wire to terminal with red band and black wire to terminal with black band).
Maintenance and Care
Your MUSICA52WRM has been designed and manufactured for years of trouble-free service.
You can clean your loudspeakers with a dampened soft cloth or paper towel. If the speaker is
mounted high on a wall or ceiling, use a broom or duster to gently brush it off. Spraying the
speaker with a high-pressure water is not recommended.
SPECIFICATIONS:
MUSICA52WRM
Frequency Response (± 3 dB)
110 Hz to 20 kHz
Power Handling (RMS/Peak Music)
75W / 150W
Sensitivity (2.83V/1M)
88dB
Transducer Complement
High Frequency
1/2” Balanced Dome Tweeter
Low Frequency
5 1/4” Polypropylene Cone Woofer
Crossover Frequency
5 kHz
Crossover Slope
12 dB/ Octave HP, 6dB/ Octave LP
Impedance
8 ohms Nominal, 4 ohms minimum
Input Connections:
5-way Binding Posts
Materials
UV-Resistant Talc Impregnated Polypropylene
Injection Molded Weatherproof Enclosure (White
Finish)
Perforated Powder Coated Aluminum Grille (White
Finish) matches enclosure color
Weight (Less Bracket)
5.2lbs. (2.4kg)
Weight (With Bracket)
5.4lbs. (2.5kg)
Dimensions (Less Bracket)
9 1/2”H (24.1cm) X 7”W (17.8cm) X 6”D (16.2cm)
MUSICA WARRANTY INFORMATION
MUSICA Loudspeakers purchased in the United States from an authorized MUSICA
dealer are guaranteed against defects in material and workmanship for a period of ten
years from the date purchased by the end user, an limited to the original retail pur-
chaser of the product. Product found to be defective during that period will be repaired
or replaced by MTX at no charge. This warranty is void if it is determined that unau-
thorized parties have attempted repairs or alterations of any nature. Warranty does not
extend to cosmetics or finish. Before presuming a defect is present in the product, be
certain that all related equipment and wiring is functioning properly.
MUSICA disclaims any liability for other incurred damages resulting from product
defects. Any expenses incurred in the removal and reinstallation of product is not cov-
ered by this warranty. MUSICA’s total liability will not exceed the purchase price of the
product. This warranty is valid in the United States only.
Proof of purchase is required when requesting service, so please retain your sales
receipt and take a moment to register your product on line @
www.MusicaAtHome.
com.