MUSIC HALL MMF-5.1, Инструкция по эксплуатации

Страница: 11 / 16

tonearm rest (8). Remove the anti-skating weight (16) from the anti-skating rod
(15). Hold the anti-skating rod (15) between your thumb and forefinger and
unscrew it using a clockwise rotation. Lift the tonearm (9) up about 2 – 3 inches
out of the tonearm rest (8). Look carefully on top of the tonearm (9) near the
area previously occupied by the anti-skating rod (15). You will see a small
setscrew. Slightly loosen this screw. This will loosen the tonearm (9) and allow
you to twist it from side to side. Position the tonearm (9) so that the stylus is
perpendicular to the record groove. Tighten the setscrew. Replace the anti-
skating rod (15) and anti-skating weight (16). Listen. You are listening for a
balanced soundstage with the greatest area and depth. You may need to go
back and forth a couple of times to achieve the best setting. Please note that
small changes in azimuth make a big difference in the sound.
*Save all packing materials, parts, and screws for possible future transport*
SITING
FLOOR MOUNTING - Place the deck on a small, light, rigid table, e.g., coffee
table. Ensure that the table is level on the floor and not rocking.
WALL MOUNTING - Wall mounting may be preferable when the floor is springy
or when there is risk of damage by children or pets. The shelf should be light
and rigid, and fully supported by, but not firmly screwed or glued to its brackets.
To allow the lid to open fully, a clearance of 3 inches (7.5 cm.) is required behind
the plinth and at least 13 inches (33 cm.) above.
AUDIO CONNECTION
The Goldring 1012GX is a moving-magnet cartridge. Connect the audio cable
(14) to the MM (Moving Magnet) phono input on your receiver or pre-amplifier.
MAINS CONNECTION
Locate the wall transformer. It’s in a small white box set into the underside of the
packing foam. Plug the small male end of the wall transformer wire into the
female receptacle on the power socket for the motor. The power socket for the
motor is located on the underside of the turntable near the back. Plug the
transformer into the wall. Turn the motor ‘ON’ (20) and check that the platter (5)
spins.
OPERATION
Place a record on the platter (5) and screw on the record clamp (found in parts
bag). Simply snug the clamp. Do not over tighten the clamp as damage to your
record or turntable may result. Push the mains switch (20) to the 'ON' position.
Remove the stylus guard and lift up the tonearm (9) with the cueing lever (7).
Position the cartridge stylus tip above the initial groove of the record. Gently
lower the cueing lever (7) to lower the tonearm (9) onto the record.
11