MUSIC HALL mmf-11, Инструкция по эксплуатации

Страница: 13 / 16

13
Position the cartridge stylus tip above the initial groove of the record. Gently lower the
lift lever (5) to lower the stylus (3) onto the record.
To stop play, lift the tonearm lift lever (5) to raise the tonearm (3) and then move the
arm back to the tonearm rest (4). Push the STBY-STOP button (22).
To play 45rpm records, first get the platter (15) spinning at 33 1/3 rpm then simply push
the ‘45’ button on the Speed Control (22). The platter will increase its speed to 45rpm.
Please note, for singles (7-inch records with a large center hole) you will need to use
the 45rpm adaptor. Simply, center the adaptor over the spindle and set it on top of the
cork mat. Place the single on the platter (15) and play.
MAINTENANCE
The mmf-11 is designed for a long operational life. To preserve the appearance of your
deck and maintain its performance, you should note the following points:
* Make sure the stylus guard is on before you begin cleaning *
PLINTHS - The plinths are constructed from medium density fiberboard, therefore they
should not be subjected to extremes of temperature or direct sunlight. The finish may
change slightly with age. A damp cloth or soft duster is ideal for cleaning the plinths:
polish, particularly wax-based, can be hard to remove.
PLATTER - The acrylic platter can be cleaned with a soft dry lint-free cloth.
MOTORS - The motors are equipped with self-lubricating bearings. The motor pulleys
should be cleaned periodically to remove deposits of rubber shed by the belt. Remove
the belt and gently clean with a cotton swab or lint-free cloth dampened with isopropyl
alcohol.
BELT - The belt should last for many years. The belt can be cleaned at the same time
as the pulleys. The best way to clean the belt is to pull it gently through a damp cloth. If
the turntable is not going to be used for a long period of time, it is advisable to remove
the belts from the motor pulleys and from the platter rim to prevent stretching.
OIL - The oil supplied for the main bearing provides life-long protection. If oil is lost from
the bearing housing, replace it with one drop of Mobil 1 or other synthetic oil containing
Teflon.
DUST COVER - This can be cleaned using any commercial acrylic or plastic cleaners.
The simplest approach is to remove any dust with a damp, lint-free cloth without rubbing
and then use a soft duster. Dust covers are more often damaged in cleaning than in
use.
STYLUS - Remove the stylus guard. We recommend a dry, vibrating-pad cleaner. Wet
cleaners or soft stylus brushes are not recommended.