MURDOCK MFG. •
15125 Proctor Avenue • City of Industry, CA 91746 USA
Phone 800-453-7465 or 626-333-2543 • Fax 626-855-4860 • www.murdockmfg.com
Member of
I N S TA L L AT I O N / M A I N T E N A N C E I N S T R U C T I O N S
Surface Mounted Bottle Fillers
7020-957-001
Revised: 08/02/19
Page 9 of 13
2. Connect the Sensor Wires to either the Solenoid Valve or -BCD Bottle Counter Display (if equipped).
ELECTRICAL INSTALLATION:
1A. Plug-In Operation: Plug transformer provided into GFCI protected electrical service, used by the Bottle Filler.
START UP:
NOTE: PLUG-IN POWER IS A STANDARD FEATURE FOR BF16.
BOTTLE COUNTER ADJUSTING & RESETTING INSTRUCTIONS:
1. Air within the Bottle Filler System or the structure supply piping will cause an irregular Spout outlet stream until
purged out by incoming water. Hold cup (or similar object) directly below Filler Spout is recommended when first
activating Bottle Filler to prevent excessive splashing. Activate sensor until steady water stream is achieved.
NOTE: Bottle Counter Has Multiple Functions
Reset/ Mode Button
• Counts refilled bottles
• Adjustable for units with and without Filters
• “REPLACEMENT FILTER” alert function
• Alert reset, when Filter is replaced
Description
Illuminated LCD Display counts bottles and has a Filter replacement alert function.
OPERATING INSTRUCTIONS:
Bottle Counting Function
The software applies a flow volume of approximately 16.9 fl oz (volume in standard size plastic water bottle) to
each bottle counted. If the flow volume is less than 16.9 fl oz, there will be no count but the volume will
accumulate, so that part way through the next cycle the total bottle count will change.
Position container to be filled directly in front of the Sensor and centered under the Filler Spout. Water flow starts
automatically. When the container is almost filled, remove container. The water will stop flowing.
Fill Spout
Sensor
-BCD Bottle Counter Display
with Illuminated Display
