© Munters Corporation, November 2019
14
QM1232r2
Step 11
Place all 4 cone sections on a flat surface with tabs from one facing slots of the next.
See Figure 11A
.
Curl up tab end of first cone section and insert tabs up into slots in the next cone section. A mallet may
be needed to seat slots over tabs completely.
See Figure 11B.
Repeat this until all 4 cone sections are
connected and laying flat.
Installation Instructions
Chapter 2
Step 12A
For
WS55xK Fan
fasten each of the joints in the single outer hole using (1) Short Bolt [K] and Nut [L], with the
nut on the side with the tabs. At the inner pair of holes of each joint attach (1) Cone Support Bracket to the
inner hole using (1) Short Bolt [K] and Nut [L] with the bolt head on the side with the tabs. For
WS55xP Fan
fasten each of the joints in the single outer hole using (1) Short Bolt [D] and Nut [E], with the nut on the side
with the tabs. At the inner pair of holes of each joint attach (1) Cone Support Bracket to the inner hole using
(1) Short Bolt [D] and Nut [E] with the bolt head on the side with the tabs.
See Figure 12A.
Figure 11A
Figure 12A
Nut [L]/[E]
Figure 11B
Outer Hole
Short Bolt [K]/[D]
Short Bolt [K]/[D]
Inner holes
Nut [L]/[E]
Cone Support Bracket
2.4 Cone Installation