© Munters AB, 2018
25
6.1.1.2
Testing voice quality
1. Select
SYSTEM > Test > Voice
.
2. Define speech VOLUME and SPEED.
3. To test, press ENTER.
NOTE:
Voice Setting and Test Voice perform the same functions.
6.1.1.3
Testing the voice call service
This menu tests the VOICE CALL service.
1. Select
SYSTEM > Test > Dial Out
.
2. Enter the required phone number to receive the “Test Call”.
3. Press ENTER.
6.1.1.4
Testing the cellular signal strength
•
Select
SYSTEM > Test > GSM/CDMA
.
This screen displays the cellular service provider’s Received Signal Strength Indicator. This screen
displays the cellular service provider’s number, name, BER (Bit Error Rate (if available)), the reception bar
graph as well as the measured signal reading.
NOTE:
Signal strength must be between -113 dBm to -51 dBm.
6.1.1.5
Receiving a status report
You can receive a status report over the phone. Refer to Status report, page 30 for details on the function.
To hear the status report:
1. Call the Communicator phone number.
2. When prompted, select Status report.
6.1.2
A
DVANCED VOICE FUNCTIONS
This section details Communicator’s advanced Voice functions.
CAUTION
Munters recommends that only trained, authorized technicians configure these functions.
•
Configuring the telephone modem, page 26
VOICE SETTING
VOLUME
ENTER NUMBER
23415
RED WIRELESS
<Ber=…>
-51 dBm
