Munters R Series, Руководство по эксплуатации и техническому обслуживанию

Страница: 11 / 141

Manual# I27028 2-1 Rev. 2 – 11/22/2017
2 - SAFETY NOTES
Munters is concerned about the safety of anyone who uses or services the R-Series
unit. Some of the parts inside the R-Series unit can be dangerous if an untrained
person tries to service the unit. Throughout this manual, hazards are pointed out which
may occur in the use of the R-Series unit. Precautions are also listed which should be
taken to avoid these hazards.
In this manual, different kinds of messages are used to warn of possible hazards:
Immediate hazard which will result in severe personal injury or
death.
Hazard or unsafe practice which may result in severe personal
injury or death.
Hazard or unsafe practice which could result in minor personal
injury or property damage.
Hazard or unsafe practice which will not result in personal
injury, but could result in property damage.
Please keep these points in mind while using or servicing the unit:
The R-Series unit may be wired for up to 575V AC. The unit
can produce enough voltage and current to cause serious
injury or death. Always turn off and lock out the power before
working inside the unit. Only trained electricians should
perform work with the electrical parts.
The blowers inside the R-Series unit spin at a high rate of
speed. Hands may be badly hurt if put inside the blower
while it is turning. Keep hands away from the blowers while
the unit is turned on. Before working with the machine, allow
enough time for the blowers to come to a complete stop.
The wheel used in a larger R-Series unit can weigh
several hundred pounds. Never attempt to lift the wheel
without help from a second person. It is usually easier to
roll the wheel. When working near the wheel when it is
inside the unit, and the wheel is propped up, use blocks to
prevent the wheel from moving accidentally.
Units designed for outdoor use are not waterproof and
weatherproof unless all covers are secured in place.
During normal operation, do not run the unit with the access
panels removed. This can allow moist air to reach parts of
the machine which should be dry.