FI Fan Insulation Panels
HC/MIT/UgGB-0560-11/05
User’s Guide – FI Fan Insulation Panels
6(12)
© Munters Europe AB, 2005
Munters reserves the right to make alterations to specifications, quantities, etc. for production or other reasons, subsequent to publication
.
3. Pull the lever of the latch back as shown in figure11. This secures the panel onto the fan.
Now do the same for the latch and hook on the other side and then the same for the two
latches on the bottom.
NOTE!
The electricity to the fan should be switched off manually when the FI panels are
mounted and it should remain in off as long as the panels are mounted.
4.3 Mounting of drainage seals
All Euroemme
®
fans have drainage holes in the bottom panel to allow for water to drain from the
fan in case of rain or when the fan is washed. If these holes are blocked during normal operation,
there is a very high risk of corrosion of the bottom panel. While the FI fan insulation panels are
installed, the fan is not operational and water should not be able to accumulate in the bottom
panel. In such instances the drainage holes can be sealed to eliminate the risk of cold drafts
through the drainage holes. For this purpose five drainage seals are provided with each FI fan
insulation panel. To install these, follow the steps below:
1. Clean the metal surface surrounding the drainage hole (figure 12).
2. Peal back the plastic cover from the adhesive label as shown in figure 13.
3. Position the drainage seal over the drainage hole as indicated in figure 14 and press down
firmly.
4. A tight seal should be formed as shown in figure 15.
Figure10 Figure
11
1
2
