ComDry Control System
1.11 Change the system settings
To change settings you must have “one-star” access, see
1.10, Access the control system
Follow these steps to change the system settings:
Step
Action
Result/Illustration
1
Navigate to the parameter you want to change by using
or
.
2
Press
.
The setting starts to flash.
3
Change the value with
and
.
4
Confirm the new setting with
.
The setting stops to flash.
NOTE!
If the new setting is not confirmed within 30 seconds, the display changes back to the old setting.
NOTE!
Read-only values are not changeable. They will not start to flash if
is pressed, regardless of access
level. To find out if a parameter is changeable or read-only, see section 2, Menus and parameters.
1.12 Reset an alarm
Follow these steps to reset an alarm:
Step
Action
Result/Illustration
1
Write down the alarm message before resetting the alarm. The
information can be helpful when troubleshooting.
2
Wait until the dehumidifier has stopped.
Press
.
The display changes to
[
Rst NO
]
and
[
NO
]
is flashing.
3
Toggle
[
NO
]
to
[
YES
]
by pressing either
or
.
Confirm by pressing
.
When the alarm has been reset, the
menu system returns to its start position.
NOTE!
If the cause of an alarm is still present, the alarm can reappear after resetting, even if the dehumidifier
is stopped.
MEN-CDCS-A1808
Operation
7
Содержание ComDry
Страница 20: ...www munters com ...
