Munters ComDry M210X, Руководство пользователя

Страница: 14 / 32

NOTE
Horizontal ducts must be installed with a slight decline away from the dehumidifier to
drain possible condensation. The decline must be at least 2 cm/m of duct. Drainage
holes (5 mm) should be made at low points of the duct to prevent water accumulation.
Fasten wire netting with a mesh width of approximately 10 mm in the outer end of the duct.
Wet air hoses are usually guided outdoors. In large premises where the dehumidifier is outside of the
space to be dehumidified, the wet air must be ducted away from the unit with a hose of minimum length
2 metres. Make sure that the wet air is not sucked back into the unit and that the wet air does not blow
against moisture sensitive objects.
5.6. Electrical connections
The dehumidifier is delivered with a 2.7 m long power cable, with a plug for connection to an earthed
outlet.
WARNING
All electrical installations must be done by an authorized electrician in accordance with
local regulations. An incorrect installation can cause electrical shock hazards and dam-
age to the unit.
The unit must never be connected to another voltage or frequency than what is speci-
fied on the identification plate. Too high line voltage can cause electrical shock hazards
and damage to the unit.
The unit must be connected to an earthed electrical outlet.
Do not operate the unit if the power cable or plug is damaged, risk of electrical shock.
CAUTION
In case of a fixed installation where the plug is replaced by a circuit breaker, make sure
that the fuse rating in the circuit breaker is correct.
The mains frequency can be adjusted, see the control system supplement.
5.7. Expanding the system
CAUTION
Never connect ComDry directly to a standard Ethernet network, even if the connector
type is the same (RJ45-8, modular connector). Doing so can damage both the ComDry
control system and/or the computer network.
ComDry M210X Dehumidifier
14