Importé par :
AIC International - 44980 Ste Luce sur Loire - France
Features
-
Table metal solar light with LED garland
-
Amorphous solar panel (located on the top of transparent ball)
-
20 warm white LED garland < 5lm
-
1 AAA NiMh 1.2V 300mAh rechargeable battery included (Not covered by warranty)
-
Lighting time: approx. 4- 6 hours (for full charge)
-
Material : metal
-
Dimensions : about 16*17.5*40 cm (approx.)
2.
First time use
a)
Assemble table light : screw with bolt and nut solar panel on metal frame.
b)
We advise to keep the light OFF during 24hours in order to well charge batteries.
c)
After 24 hours, set the switch to the “ON” position (on the bottom of the candle).
d)
Place the solar light in a location where it can receive a full 8 hours of sunshine to allow
the rechargeable battery to reach maximum capacity.
The switch has to be left in the “ON” position and the light will turn on automatically at dusk.
3. Battery replacement
Note: this operation should be done in the morning on a sunny day. This will allow the lantern to
receive a full 8 hours of sunlight so that the rechargeable battery can reach maximum capacity.
Move the switch into the position OFF
Unscrew solar panel from metal frame, then unscrew transparent ball
Unscrew all 2 screws on the battery compartment
Remove the used battery and replace with 1 new AAA size 1.2V rechargeable batteries of same
or greater capacity (mAh). ----------------USE RECHARGEABLE BATTERY ONLY!!!
Screw the 2 screws back in again with an adequate screwdriver.
Keep the light OFF during 24hours in order to well charge batteries. After 24 hours, set the
switch to the “ON” position
4. Troubleshooting and Caution
If your solar light does not operate properly at night, it may be caused by one of the following:
Ensure that the solar lantern is in a bright sunny location and not in a shady are during the day.
Make sure that the switch is turned on.
Other lights can cause flickering in a solar light or even prevent it operating.
Check the battery in case it needs replacing: see “Maintenance” above.
LED can’t be changed
5. Note:
Safe for outdoor use.
Remove the batteries if consumed or if the product is to be left unused for a long period of time.
Low winter light lever in your location may lead you to decide to store your light indoor until
condition improved. If so, clean and dry the solar panel, turn off the switch or remove the
