Muncie APEM-SCNT-1, Руководство по эксплуатации и настройке, Страница: 13 / 16

SNOW & ICE DIVISION PAGE 12
CONFIGURATION MENU
BODY SPREADER
SETTINGS:
Auger Min/Max: The min setting should be adjusted
so that the auger is barely turning. The max setting
is the maximum preferred auger speed.
Spinner Min/Max: The min setting should be
adjusted so that the spinner is barely turning.
The max setting is the maximum preferred
spinner speed.
Liquid Min/Max: The min setting should be adjusted
so that the liquid is barely flowing from the spray
nozzles. The max setting is the maximum preferred
liquid speed.
Auger OL Cal Const: The calibration values are
automatically populated after a weighted dump
calibration process. These values can be transferred
to other controllers where the spreader body setup
is identical.
Spread Cal: This screen is intended for calibrating
the spreader system (weighed dump calibration).
Purpose—The spreader calibration is recommended
for auto mode accuracy. It allows the controller to
accurately discharge material at the rate shown and
accurately log how much material is discharged.
1. Load the spreader with the primary material and
weigh the truck. Before beginning the unloading
process, increase and hold the engine at 1,000 RPM
for this process.
2. Set the Drive % between the min and max
settings. Depress the spinner knob to begin the
spreader offloading process.
3. Allow the spreader to unload for 5-7 minutes.
During the unloading process, depress the spinner
to end the offloading process.
5. When the offloading process is complete:
A. Reweigh the truck and calculate the amount
of material dumped.
B. Use the liquid and spinner knobs to enter the
weight of material dumped.
C. Depress the spinner knob to enter the value.
D. Exit the calibration menu.
BODY SPREADER
AUGER MIN MAX
013% 65%
SPINNER MIN MAX
015% 040%
LIQUID MIN MAX
015% 040%
AUGER OL CAL CONST
SPREAD DRIVE RUN
CAL 039% START