CYLINDER CONTROL
Cylinder Panel Operation (If installed):
1. Push the appropriate arrowed buttons to operate the plow and other auxiliary
pieces of equipment.
2. The backlighting on the arrowed buttons will change from green to red to
indicate successful solenoid activation on the cartridge valves.
3. If Plow float is configured, press the plow down button 2 times in a 5 second
increment to enable. The Plow Down Button should latch red to indicate this
feature is enabled. Press the plow up button to cancel.
When enabled, this feature allows the plow to follow the contour of the road
providing better plow performance.
Joystick Operation (If installed):
1. Select cylinder operation (Plow, Dump, Auxiliary) by momentarily pressing the
appropriate button on the joystick head. The selection will latch the function until
another function is selected. The mode will be displayed on the touch screen of
the spreader panel. If the system is turned off and then restarted No function is
selected by default a selection must be made before using the joystick to
control any piece of equipment.
2. The Dead-Man Switch must be depressed while actuating the joystick and held
throughout the operation. If the trigger is released during operation, the operation
will cease.
3. If Plow float is configured, with the plow selected, actuate the joystick forward 2
times in a 5 second increment to enable. The plow down button on the cylinder
panel should latch red to indicate this feature is enabled. Press the plow up
button to cancel.
When enabled, this feature allows the plow to follow the contour of the road
providing better plow performance.
Plow
Auxiliary
Dump
Dead-man
Switch
