Munchkin MKSA0646-REV1, Руководство пользователя

Страница: 8 / 29

How To Install How To Install
14 15
3.
Determine whether there is a stud behind the
drywall where you will install the upper catch
wall bracket. Proceed to either
4a or 4b .
4a. For Drywall Without Stud / Plasterboard:
Drill a 7/32”(5.5mm) hole into the drywall at each
pencil center mark. Insert a drywall anchor into
each hole.
Use a screwdriver or drill to insert the screws
through the upper catch wall bracket into the
drywall anchor.
4b. For Drywall with Stud:
Drill a 5/64” (2mm) pilot hole into the stud at each
pencil mark (no anchor needed).
Use a screwdriver or drill to insert the screws
through the upper catch wall bracket into the stud.
4a. Drywall
4a. Plasterboard
4b. Stud
7/32"
5.5mm
Drywall
anchor
Large
screw
Large
screw
7/32"
5.5mm
5/64"
2.0mm
ADJUSTING BOLT ADJUSTER
Check again that the center button on the upper and lower catch wall brackets are being
fully pressed in by the bolt adjuster. If so, use the wrench to firmly tighten the nut.
PLEASE NOTE:
The gap between the gate to the wall should be less than 2.6” (66mm).
TOOLS NEEDED:
•
Wrench
• Hex Key
A
B
<2.6" (<66mm) <2.6" (<66mm)
A
B
Upper catch
bracket
Lower
catch
bracket