Multiva Cerex 300 SeedPilot, Руководство по эксплуатации и обслуживанию

Страница: 34 / 165

2896
The RDS hopper sensors (1) are capacitive sensors located in the hopper. As a standard feature,
there are two hopper sensors in the machine: one in the seed hopper and one in the fertiliser
hopper on the left side of the machine. Hopper sensors are also available as an accessory for the
right-hand side hoppers of the machine, in which case the total number of hopper sensors will
be 4. If the seed or fertiliser level in the hopper is too low, an alarm will be triggered in the RDS
controller.
4.2.7. Tramline couplings
Figure. 4.2.7. - 18. Tramline couplings
The tramline couplings (1) are located on both ends of the feeder unit. The couplings have been
installed on both the seed and the fertiliser side. The total number of tramline couplings in the
machine is 4. The coupling can be used to disconnect one feeder.
Figure. 4.2.7. - 19. Notched feeder roller
The tramline coupling comes with one notched feeder roller (1) as a standard feature. When the
tramline coupling is powered on, the notched feeder roller does not rotate. During the seeding
operation, a tramline is generated when a row is not seeded.
Operation and maintenance
manual
Cerex 300
1.00
33 (156)