Multitone BSR 113, Техническое руководство, Страница: 26 / 63

BSR 113
TM1194A Issue B Page 4 - 2
INSTALLATION
2. The BSR 113 can be either shelf or wall mounted. Ensure that it is mounted within
three metres of an AC mains power supply outlet.
CAUTION
DO NOT INSTALL THE RECEIVER WHERE IT MAY BE EXPOSED TO LIQUIDS,
STRONG MAGNETIC FIELDS, EXTREME TEMPERATURES OR STRONG
SUNLIGHT.
CAUTION
STATIC SENSITIVE DEVICES ARE USED WITHIN THIS EQUIPMENT. CARE
MUST BE TAKEN TO ENSURE DAMAGE TO THESE DEVICES IS NOT CAUSED
BY HIGH LEVELS OF STATIC ELECTRICITY. SPARE BOARDS OR
COMPONENTS SHOULD BE STORED IN ANTI-STATIC PACKAGING WHEN NOT
INSTALLED IN THE EQUIPMENT.
Shelf Mounting
3. The base of the BSR 113 is fitted with four rubber feet that provide a non-slip grip
on a flat surface suitable for shelf mounting.
Wall Mounting
4. To wall mount the BSR 113 proceed as follows:
a) Referring to Figure 1, mark, drill and plug the four fixing holes.
b) Remove the four rubber feet from their retaining holes on the base of the
receiver.
c) Remove the two screws located at the rear of the receiver and carefully lift the
cover off, taking care not to detach the speaker wires.
d) Screw the base of the receiver directly onto the wall using 4mm round/pan
head screws, taking care not to damage the PCB. Four clearance holes have
been pre-cut into the PCB to allow the screws access through to the receiver
base.
e) Replace the receiver cover by fitting the front of the cover onto the base first
and then bringing the rear of the cover down onto the rear of the base,
ensuring that back cover plate is correctly seated. Replace the two screws at
the rear of the receiver.