![Multitek DIP-01 Скачать руководство пользователя страница 10](http://html1.mh-extra.com/html/multitek/dip-01/dip-01_installation-and-user-manual_1856296010.webp)
9
IMPORTANT NOTE:
While
INTERCOM
page is on the screen, if
OTHER CALLS
icon is touched
a page with
DOOR1, DOOR2, DOOR3
icons appears. It is possible to monitor
DOOR1, DOOR2,
DOOR3
door panels by just touching those icons. It is also possible to change the name and door
numbers of these icons through visiting
SETUP/ SPEED CALL/ DOOR1, DOOR2, DOOR3
. After
that, one touch on
OTHER CALLS
page brings the door cameras to the screen.
Figure 9. SETUP / SPEED CALL page
7) UPGRADING FIRMWARE OF DIP-01 BY AN SD CARD
The following steps are done:
i) Take out the ethernet cable of the device.
ii) Remove four screws and open the back lit and see the SD card holder.
iii) Insert the SD card with the latest firmware into SD card holder.
iv) Make all S1-S8 switches to ON position.
v) Then, insert the Ethernet cable to give the power to the device.
vi) Wait for 3 minutes. Then, again take out the Ethernet cable, make S1-S8 switches OFF,
take out SD card, place the lit back. Give the power again by inserting the Ethernet
cable. Three minutes later the device becomes ready to use.
vii) You program the device as explained in the section 3 as a indoor room panel.