Multitech RouteFinder MTASR3, Руководство пользователя, Страница: 14 / 113

Chapter 2 - Installation
MTASR3-200 14
Adding RAM
A second SIMM connector is provided for adding RAM to the RASFinder. The procedure for adding
RAM follows.
1. Ensure that the external power supply is disconnected from the RASFinder.
2 . Turn the RASFinder upside down and remove the cabinet mounting screw at the center/back of
the cabinet.
Figure 2-3. Cabinet Mounting Screw
3. Turn the RASFinder right side up, then slide the base out the rear of the cabinet.
4. Position the base so the front panel LEDs are toward you (as in Figure 2-4).
Note: As long as both SIMMs are identical in type, size, and speed, the RAM in this unit can be
expanded from 8 MB to 16 MB, or 32 MB, total.
5. Slant the SIMM at a 45
o
angle to the back of the base and align the centering notch of the SIMM
with the center tab on the SIMM connector.
6. Gently press down on the ends of the SIMM until the two short vertical white pins enter the holes
at the ends of the SIMM and the two metal side clips snap in place over the SIMM, locking it
down.
Figure 2-4. Installing a SIMM
7. Align the base with the mating guides on the inside of the cabinet, then slide the base all the way
into the cabinet until it stops.
8. Turn the RASFinder upside down and replace the cabinet mounting screw that was removed in
step 2.
9. Turn the RASFinder right side up and return to the previous section, Cabling Your RASFinder to
connect the cables.