Multitech RouteFinder MTASR2-203, Руководство пользователя, Страница: 22 / 90

RouteFinderT1 User Guide
MTASR2-203 22
17. If you disabled IPX and then clicked OK from the IPX Protocol Default Setup dialog box (step 12), the
IP Protocol Default Setup dialog box is now displayed.
18. To change the IP parameters, proceed to the next step. Otherwise, click on the OK button to open the
WAN Ports Default Setup dialog box, then advance to step 24.
19. The default Ethernet IP Address has to be changed to your unique LAN address. Assign an
acceptable unique IP Address to the Ethernet port.
20. Change the default Subnet Mask and Frame Type to the value assigned to your LAN port.
21. The default WAN 1 address has to be changed to your unique WAN 1 address. Assign an acceptable
unique WAN 1 port address in the Address field.
Change the default Subnet and Remote Address for the WAN port address to the values assigned to
your WAN (applies to both WAN 1 and WAN 2).
If WAN 2 is to be used (e.g., for Dial Back-up), the default WAN 2 address has to be changed to your
unique WAN 2 port address in the WAN 2 Address field.
22. Click OK when you are satisfied with your selections.
23. The WAN Ports Default Setup dialog box is displayed allowing you to configure WAN 1 for a T1
connection and WAN 2 for an optional connection.
WAN 1: The Clocking option will most likely be External. If your T1 service requires Internal clocking,
click the Internal option.
WAN 2: If the WAN 2 port is connected to a synchronous device, select Synchronous; the default
uses an external clock in the synchronous device. If you are using the RouteFinder’s internal clock,
select Internal Clock and select the appropriate Clock Speed from the pull-down list.
If the WAN 2 port is connected to an asynchronous device, select Asynchronous. Note that the
Direct Connect / Leased Line option must be disabled; if not, click (check) the box to disable it. The
Modem Type and Dial Number fields become active. Select your external modem from the pull-down
list. The Speed can either be left at the default 115200 value or set to the maximum capability of your
modem.
If the WAN 2 port is being set up to make a call, enter the telephone number to be dialed in the Dial
Number field.
If the WAN 2 port is being set up to answer a call, click the Answering option (the Dial Number field
becomes inactive).