GETTING STARTED WITH THE MTQ-MNA1-B02
MultiConnect
®
Dragonfly
TM
MTQ-MNA1-B02 Device Guide
23
The device is configured for Verizon.
To switch carrier networks:
From AT&T to Verizon:
AT#FWSWITCH=1,1
From Verizon to AT&T:
AT#FWSWITCH=0,1
Note:
For the Link status (LS) LED to function, you must issue the command AT#GPIO=1,0,2 any time you use
the firmware switch command (AT#FWSWITCH=0 or AT#FWSWITCH=1).
Powering Down Your Device
CAUTION:
Failing to properly power down the device before removing power may corrupt your device's file
system.
To properly power down your device, do one of the following options:
Option 1:
:
1.
Issue the AT#SHDN command.
2.
Wait 30 seconds.
3.
Power off or disconnect power.
Option 2:
1.
Hold the NRESET signal (pin 35) low for at least 1 second.
2.
Disconnect power.
Device Reset (NRESET Pin 35)
Software:
Issue command AT#REBOOT to reboot the device and ATZ for soft reset.
Hardware:
Hold NRESET low for >50ms and <1s.
Configuring Low Power Options
Refer to
Powering Down the Device
for lowest power consumption.
To configure PSM:
AT+CPSMS
To configure eDRX:
AT+CEDRXS
To set device functionality:
