Multitech ISI4608, Руководство пользователя

Страница: 43 / 77

43
Chapter 3 - Driver Installation
- Select Continue.
5. To verify that the files have been copied onto the floppy disk, use
these commands:
# scosh
- Select Manager.
- Select Archive.
- Select List.
- Make sure Device is pointed to the floppy disk.
- Select Continue.
To install driver from floppy disk
(Users starting with the untarred SCO5 driver on a floppy disk can
begin the installation here).
1. Run the custom utility.
2. Select Software.
3. Select Install New.
4 Highlight driver file from local host and select Continue.
5. Select as the Media Device “Floppy Disk Drive.”
6. Select Continue .
7. Highlight “Multi-Tech ISA/PCI ...” and select Install.
8. Enter Y (yes) to continue installing the ISI driver.
9. As many as four ISI4608 cards can be installed in the server.
Type 1, 2, 3, or 4, based on the number of ISI4608 cards you are
installing in your system. Type the base I/O address and the IRQ
value for each card. Be sure that the I/O address and the IRQ value
match the values set in the DIP switch and jumper block on the
ISI4608 card. (The I/O Address DIP Switch and the IRQ Jumper
Block are at the top middle of the ISI4608 circuit board and on the
component side.)