Multitech CC1600 Series, Руководство пользователя

Страница: 35 / 76

35
Chapter 4 - Modem Commands, S-Registers & Result Codes
COMMAND: &En
VALUES: n = 0 thru 15
DEFAULT: &E1, &E4, &E6, &E10, &E13, &E15
DESCRIPTION: &E0 selects no error correction.
&E1 selects V.42 Auto-reliable Mode.
&E2 selects V.42 Reliable Mode.
&E3 selects no modem-initiated flow control.
&E4 selects CTS modem-initiated flow control.
&E5 selects Xon/Xoff modem-initiated flow control.
&E6 selects Xon/Xoff not passed through.
&E7 selects Xon/Xoff passed through.
&E8 selects Enq/Ack pacing off.
&E9 selects Enq/Ack pacing on.
&E10 selects Normal Mode flow control off.
&E11 selects Normal Mode flow control on.
&E12 selects Pacing off.
&E13 selects Pacing on.
&E14 selects data compression disabled.
&E15 selects data compression enabled.
COMMAND: %En
VALUES: n=0 thru 5
DEFAULT: %E1
DESCRIPTION: %E0 = Modem Won’t Escape.
%E1 = +++ Method (default setting).
%E2 = Break Method.
%E3 = ++ or Break Method.
%E4 = No "OK" Response to +++
%E5 = "OK" Response to +++
COMMAND: #Fn
VALUES: n = 0 thru 2
DEFAULT: #F2
DESCRIPTION: #F0 means no fallback when on-line.
#F1 means fallback from 33600 to 4800 bps when on-line
(increments of 2400 bps).
#F2 means fallback to 4800 bps from 33.6Kbps/fall forward if line
improves (increments of 2400 bps).
COMMAND: &Fn
VALUES: n = 0, 8 or 9
DEFAULT: &F8
DESCRIPTION: &F loads factory default values from ROM.
&F8 reads factory default values when &F is issued.
&F9 reads parameters stored in nonvolatile memory when &F is
issued.
COMMAND: $Fn
VALUES: n = 0 or 1
DEFAULT: $F1
DESCRIPTION: $F0 means do not fall back to normal connect if CR received.
$F1 means fall back to normal connect if CR received.