MultiTable Mod-E Pro, Руководство по сборке, Страница: 3 / 11

ASSEMBLY
MultiTable Mod-E Pro Electric Standing Desk Frame
With the table top facing down on a soft, clean surface , arrange the frame as shown below, with the short ends of the top supports toward the rear.
• Position the frame side to side.
— Loosen all eight set screws (if necessary) using the 5mm Allen key. Expand or compress he frame so that the top supports are aligned with the
pre-drilled holes. Center the middle portion of the cross channels, the tighten the eight set screws.
• Position the frame font to back.
— With tables that are 24.0" deep, position the rear cross channel 6.5" from the rear edge of the table. With 29" tables, position the rear cross channel 9.5"
from the rear edge of the table. These positions of the frame will align the rear of the feet to the rear of the table when the feet are installed in step 4.
• Use the #10 x 5/8" wood screws. The small frame requires 16 screws (eight for the frame abd eight for U-brackets) and the standard frame requires 12 screws.
• Withthe small frame, position the U-brackets between the set screws. The U-brackets take the place of the cross supports on the standard frame.
9.5" with 29" table
foot for
29" table
#10 x 5/8"
Wood Screws
Standard frame
cross support
(Standard frame only)
U-bracket
(S mall frame only)