ASSEMBLY INSTRUCTIONS FOR DRAWER BOX
AND METAL RUNNER
9 Nevilles St, Underwood, Brisbane, QLD 4119
Ph: 07 3208 6799 Fax: 07 3290 6332
Int Ph: +61 7 3208 6799 Int Fax: +61 7 3290 6332
Email: [email protected]
www.multistore.com.au
© Multistore Industries (Aust) Pty Ltd
CAREFULLY REMOVE DRAWERS FROM THE
CARTON AND LAY FLAT ON THE FLOOR.
PLACE A FEW DROPS OF WOOD GLUE
(NOT SUPPLIED) IN DOWEL HOLES AND V
JOINTS
(REFER DIAGRAM)
STEP 1.
GLUE IS OPTIONAL/NOT SUPPLIED
STEP 2.
PLACE THE DRAWER BOTTOM INTO
GROOVE ON THE DRAWER WITH THE WHITE
SIDE TO THE TOP OF THE DRAWER.
GENTLY FOLD THE REMAINING SIDES
AROUND THE DRAWER BOTTOM UNTIL
DOWELS ARE ALIGNED WITH HOLES, PUSH
DOWN FIRMLY AND WIPE OFF ANY EXCESS
GLUE FROM JOINTS.
STEP 3.
TURN DRAWER BOX UPSIDE DOWN.
TAKE RUNNER, INSERT THE TAB INTO 5mm
HOLE IN BACK OF DRAWER PUSH
FORWARD AND THEN PUSH DOWN SO THE
FRONT OF THE TAB WILL ALIGN WITH 5mm
HOLES IN THE FRONT OF THE DRAWER
ONCE FIRMLY IN PLACE USE 5/8 X 6
SCREWS PROVIDED TO FIX RUNNER.
BY USING THE 12mm X 5mm BOLT SUPPLIED
INSERT INTO 5mm PRE-DRILLED HOLES IN
FRONT OF DRAWER.
ALIGN THE ALUMINIUM HANDLE WITH ONE
END OF THE DRAWER AND TIGHTEN SCREW.
DO THE SAME FOR THE OTHER END.
DO NOT OVER TIGHTEN SCREWS.
STEP 4.
DRAWER BOTTOM
5/8 X 6 SCREW TO
FIX RUNNER
BACK OF
DRAWER
5mm HOLES TO
TAKE QUICK FIX
RUNNER