Multistore EXC-750H1, Руководство по сборке, Страница: 4 / 7

1 x DRAWER ASSEMBLY INSTRUCTION
STEP 1.
LAYOUT YOUR DRAWER PIECES FLAT AS PER DESIGN WITH PRE -
DRILLED HOLES FACING UP.
START WITH THE BACK OF THE FRONT DRAWER AND PLACE YOUR
DOWELS & CAM PIN IN THE PRE
- DRILLED HOLES ON EITHER SIDE AS
INSTRUCTED BELOW
.
NO MODEL DESCRIPTION QTY
6 CAMS 2
7 CAM PINS 2
8 30mm 8 GAUGE SCREW 3
9 EURO SCREWS 4
10 HANDLE 1
11 RUNNERS PER SET 1
NO MODEL DESCRIPTION QTY
1 CONFIRMAT SCREWS 4
2 DOWELS 4
3 BACKING NAILS 20
4 5/8 X 6 WOOD SCREWS 6
5 INFILL 1
STEP 2.
G
RAB
YOUR FIRST SIDE AND INSERT YOUR CAMS
INTO THE HOLE PROVIDED ON THE OUTSIDE OF THE
DRAWER GENTLY AS PER INSTRUCTIONS BELOW.
PUSH THE SIDE INTO THE FRONT DOWELS & PIN THEN CAREFULLY USING A SCREW DRIVER TURN
UNTIL IT LOCKS IN. REPEAT THIS PROCESS WITH THE OTHER SIDE.
NOW PLACE YOUR LAST PIECE BETWEEN THE TWO SIDES USING THE
SCREWS NO.1 SUPPLIED SCREW INTO THE SIDES OF THE BACK
DRAWER PIECE.
IMPORTANT NOTICE:
PLACE THE FITTING OVER THE HOLE
KEEPING THE SQUARE EDGE OF THE
FITTING PARALLEL TO THE FACE OF
THE BOARD, KNOCK IN CAREFULLY
.