MultiScreen In House TV Communication System, Руководство оператора

Страница: 16 / 234

MultiScree
16
Caring for Your Production Unit
Follow the suggestions below to keep your valuable system in good condition.
Care of the Production Unit

Never turn the power button off or move the system while the hard disk drive
is reading or writing, as indicated by the hard disk activity light. Doing so
may cause damage to the information stored on the hard disk. The system
should always be properly shut down as described on
page 103
before being
switched off.

Whenever you turn off the Production Unit, always wait at least ten seconds
before turning it back on again. If you don‟t observe this precaution, you may
damage the Production Unit‟s circuitry.

Avoid dropping or jarring your Production Unit. This loosens memory chips
and expansion cards, and can severely damage the hard disk drive. Always
shut down the Production Unit prior to moving it, even if it‟s only to the other
side of the desk.

Do not set up your system in a room with extreme conditions of temperature
and/or humidity.

Do not allow heat to build up inside of the system unit. Ensure that the vents
on the top, sides and rear of the Production Unit are never blocked.

Do not spray any kind of cleaning liquid directly on the case or keyboard. In-
stead apply it onto a soft cloth. Always turn the power off and unplug each
power cable from its power source before cleaning.

Use the Production Unit in as clean & dust-free an environment as possible.

Do not eat or drink while operating the Production Unit.