MULTIQUIP R2000H, Руководство по эксплуатации и запасным частям

Страница: 20 / 90

PAGE 20 —R2000H RIDE-ON STATIC ROLLER — OPERATION & PARTS MANUAL — REV. #4 (07/24/08)
R2000H — ENGINE COMPONENTS
Figure 5. Engine Controls and Components
INITIAL SERVICING (ENGINE)
The engine (Figure 5) must be checked for proper lubrication and
filled with fuel prior to operation. Refer to the manufacturer's engine
manual for instructions and details of operation and servicing.
1 . Fuel Filler Cap/Fuel tank – Remove this cap to add
unleaded gasoline to the fuel tank. Make sure cap is
tightened securely.
DO NOT over fill. Fuel tank capacity is
1.59 gallons (6.0 liters). Use unleaded gasoline. For
additional information refer to Honda engine owner's
manual.
6 . Choke Lever – Used in the starting of a cold engine, or in
cold weather conditions. The choke enriches the fuel
mixture.
7 . Air Cleaner – Prevents dirt and other debris from entering
the air intake system. Remove wing-nut on top of air filter
cannister to gain access to filter element.
8 . Spark Plug – Provides spark to the ignition system. Set
spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean
spark plug once a week.
9 . Muffler – Used to reduce noise and emissions.
Engine components can generate extreme heat.
To prevent burns,
DO NOT touch these areas
while the engine is running or immediately after
operating.
NEVER operate the engine with the
muffler removed.
10 . Ignition Switch– Use this switch to start and stop the
engine.
11 . Circuit Breaker– Protects the battery charging circuit. See
Honda owner's manual for additional information.
DANGER
WARNING
Adding fuel to the tank should be done only when
the engine is stopped and has had an opportunity
to cool down. In the event of a fuel spill,
DO NOT
attempt to start the engine until the fuel residue has been completely
wiped up, and the area surrounding the engine is dry.
2 . Throttle Lever – Used to adjust engine RPM speed (lever
advanced forward
SLOW
, lever back toward operator
FAST ).
3 . Engine ON/OFF Switch – ON position permits engine
starting, OFF position stops engine operations.
4 . Recoil Starter (pull rope) – Manual-starting method. Pull
the starter grip until resistance is felt, then pull briskly and
smoothly.
5 . Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop
the flow of fuel.
Operating the engine without an air
filter, with a damaged air filter, or a
filter in need of replacement will allow
dirt to enter the engine, causing rapid
engine wear.
NOTE