PAGE 24 —R2000 RIDE-ON STATIC ROLLER — OPERATION & PARTS MANUAL — REV. #2 (03/20/06)
Figure 15. Traveling Forward
3. The speed of the roller is directly proportional to the amount
of pressure being applied to the lever in each direction. Travel
speed is between 0 and 4 mph (6.4 kph). The transmission
control lever may be moved forward or reverse at any engine
speed. However, it should not be moved rapidly as damage
to the drive train may result.
4. Further adjustment of travel speed can be made by changing
engine throttle setting. Maximum speed is attained with
maximum engine speed and full forward or reverse lever
position. Maximum power is attained with lever just out of
neutral position and maximum engine speed
4. Insert the ignition key into the ignition (Figure 14), place key
in the
start
position, when engine starts release key.
Figure 14. Ignition Switch
OPERATION
1. Release the parking brake by pushing down on the parking
brake lever.
The
parking brake
must be used to hold the
roller in the "
stopped
" condition. The
transmission system will not hold the roller in a
"stopped" condition.
WARNING
R2000 — OPERATION
Transmission control lever must be in neutral
position when starting engine.
NEVER
engage
transmission abruptly because this places
unnecessary high loads on all drive line
components.
WARNING
5. If the engine does not start, repeat steps 1 through 4 or consult
the troubleshooting guide contained in this manual.
6. Let the engine warm for 3 to 5 minutes before using roller.
Check for fuel and oil leaks, and noises that would asso-
ciate with a loose guard and/or covers.
7. If necessary return the choke knob to the full
OPEN
position.
2. To make the roller move in a
forward direction
, move the
transmission control lever forward as shown in Figure 15.
Make sure lever is securely place into notch.
NOTE
To
slow
or
stop
roller, move the
transmission control lever toward
the
neutral position
. If roller still
cannot be slowed or stopped
using the hydraulic braking sys-
tem, use the
parking brake
to
slow and then stop the roller.
Содержание R2000
