MULTIQUIP QP-402H, Руководство по эксплуатации и запасным частям

Страница: 15 / 70

QP-402H CENTRIFUGAL PUMP — OPERATION AND PARTS MANUAL— REV. #1 (04/02/08) — PAGE 15
QP-402H — BASIC ENGINE
Figure 4. Engine Controls and Components
INITIAL SERVICING
The engine (Figure 4) must be checked for proper lubrication and
filled with fuel prior to operation. Refer to the manufacturers engine
manual for instructions and details of operation and servicing. The
engine shown above is a
HONDA engine, operation for other
types of engines may vary somewhat.
1 . Fuel Filler Cap – Remove this cap to add unleaded
gasoline to the fuel tank. Make sure cap is tightened
securely.
DO NOT over fill.
6 . Choke Lever – Used in the starting of a cold engine, or in
cold weather conditions. The choke enriches the fuel
mixture.
7 . Air Cleaner – Prevents dirt and other debris from entering
the fuel system. Remove wing-nut on top of air filter
cannister to gain access to filter element.
8 . Spark Plug – Provides spark to the ignition system. Set
spark plug gap to 0.6 - 0.7 mm (0.028 - 0.031 inch) Clean
spark plug once a week.
9 . Muffler – Used to reduce noise and emissions.
10 . Fuel Tank – Holds unleaded gasoline. For additional
information refer to engine owner's manual.
Operating the engine without an
air filter, with a damaged air filter,
or a filter in need of replacement
will allow dirt to enter the engine,
causing rapid engine wear.
2 . Throttle Lever – Used to adjust engine RPM speed (lever
advanced forward SLOW , lever back toward operator
FAST ).
3 . Engine ON/OFF Switch – ON position permits engine
starting, OFF position stops engine operations.
4 . Recoil Starter (pull rope) – Manual-starting method. Pull
the starter grip until resistance is felt, then pull briskly and
smoothly.
5 . Fuel Valve Lever – OPEN to let fuel flow, CLOSE to stop
the flow of fuel.
NOTE
Engine components can generate extreme heat.
To prevent burns,
DO NOT touch these areas
while the engine is running or immediately after
operating.
NEVER operate the engine with the
muffler removed.
CAUTION - Burn Hazard
CAUTION - Fueling The Engine
Adding fuel to the tank should be done only when
the engine is stopped and has had an
opportunity to cool down. In the event of a fuel
spill,
DO NOT attempt to start the engine until
the fuel residue has been completely wiped up,
and the area surrounding the engine is dry.