MULTIQUIP GAC6HR, Руководство по эксплуатации и запасным частям

Страница: 19 / 60

GAC6HR/HRS 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (12/13/17) — PAGE 19
COMPONENTS (GENERATOR)
GAC-6HR
120 V
120
120V
240/120V QUARTZ QUARTZ
120 V
120
MAIN AC CIRCUIT BREAKER
DISJONCTEUR PRINCIPALE DE COURANT CA
120V
240/120V
1
4 5
6
120V 20A 120V 30A 120/240V 20A
NEUTRAL BONDED TO FRAME.
NEUTRE MIS A LA MASSE A
LA CARCASSE DU MOTEUR.
HOUR METER
COMPTEUR
D’ HEURE
120V 20A
FULL POWER
SWITCH
INTERRUPTEUR
PLEINE
PUISSANCE
MARCHE ON
ARRET OFF
MARCHE ON
ARRET OFF
IDLE
CONTROL
CONTROL
DE RALENTI
OPERATION
SWITCH
INTERRUPTEUR
DU OPERARION
TOTAL LOAD WITHIN 5kW
CHARGE TOTALE MAX. 5kW
OFF
GR
PRISE DE
TERRE
AC VOLTMETER
VOLTOMETRE CA
3
2
7
13 12
GAC-6HRS
120 V
120
120V
240/120V
QUARTZ QUARTZ
120 V
120
MAIN AC CIRCUIT BREAKER
DISJONCTEUR PRINCIPALE DE COURANT CA
120V
240/120V
120V 20A 120V 30A 120/240V 20A
NEUTRAL BONDED TO FRAME.
NEUTRE MIS A LA MASSE A
LA CARCASSE DU MOTEUR.
HOUR METER
COMPTEUR
D’ HEURE
120V 20A
FULL POWER
SWITCH
INTERRUPTEUR
PLEINE
PUISSANCE
MARCHE ON
ARRET OFF
MARCHE ON
ARRET OFF
IDLE
CONTROL
CONTROL
DE RALENTI
OPERATION
SWITCH
INTERRUPTEUR
DU OPERARION
TOTAL LOAD WITHIN 5kW
CHARGE TOTALE MAX. 5kW
OFF
GR
PRISE DE
TERRE
AC VOLTMETER
VOLTOMETRE CA
START
BUTTON
BOUTON DE
DEMARRAGE
8
11
9
10
Figure 4. Generator Components
1.
GFCI Duplex Receptacles – NEMA 5-20R, GFCI
receptacle will provide 120V@ 20 amps.
2.
Main Breaker – This 2-pole, 20 amp circuit breaker
protects the generator from short circuiting or
overloading. When starting the generator always have
the circuit breaker placed in the "
OFF" position.
3.
Hour Meter – Indicates the number hours the generator
has been in use.
4. AC-Voltmeter – This voltmeter indicates (with a
mark) the rated 60 Hz (single-phase) output voltage.
In addition, the voltmeter can also be used as a
diagnostic tool. If the voltmeter indicator (needle) is
below the rated voltage, engine problems may exist
(low/high RPM's). To prevent damage to the generator
or power tools turn the generator
OFF and consult your
authorized Multiquip service dealer.
5.
Idle Control Switch – The generator is provided with
an automatic idle control device for noise suppression
and reduced fuel consumption.
The automatic idle control automatically engages under
a no-load condition. With the automatic idle control
switched “
ON”, the engine revolutions will automatically
drop to about 2600 rpm (low-speed operation) within
3 seconds after the load stops. When the operation is
resumed, the engine speed is automatically increased
to about 3600 rpm (high-speed operation) as soon as
the load is connected.
6.
Operation Switch –Place switch in the "ON" position
(up) for normal operation. To turn-off the generator,
place the operation switch in the "OFF" position (down).
7.
Lifting Bail Eye – Attach a rope or chain to this lifting
eye when lifting of the generator is required. Never
stand underneath the generator while it is being lifted.
Place lifting eye in down position when not in use.
8.
Start Switch – Press this pushbutton switch to start
the generator (GAC6HRS only).
9.
Ground – This ground connection point should be
connected to a good earth ground ground rod).
10. 120/240V Output Receptacle – NEMA L14-30R twist-
lock receptacle will provide 240V, 60 Hz @ 20.8 amps,
or 120V@ 41.6 amps (X2) 60 Hz. Depending on the
position of the full power switch.
11. 120V Output Receptacle – NEMA L5-30R twist-lock
receptacle will provide 120V, 30 amps, 60 Hz.
12.
Battery – This unit is equipped with a 12 VDC
battery. Replace with only recommended type battery
(GAC6HRS only).
13. Charcoal Canister – A container filled with activated
charcoal that traps gasoline vapors emitted by the
fuel system.