PAGE 16 — PRO12 HYDRAULIC MIXER • OPERATION AND PARTS MANUAL — REV. #3 (09/25/14)
1.
Engine Cover
— Lift this cover to gain access to the
engine or electric motor.
2.
Start/Stop Switch
— This switch is located on the side
of the engine cover. When activated it will shut down
the engine (gasoline only).
3.
Latch
— Use this latch to secure the engine
compartment enclosure.
4.
Drum Bearing
— There is a pillow block bearing on
each end of the mixing drum. Bearings require daily
greasing with lithium-based EP grease.
5.
Mixing Paddles
— This mixer uses plastic and rubber
mixing paddles for the mixing of plaster and mortar.
Always clean paddles after each use.
6.
Bag Cutter
— This feature allows mixing bags to be
opened easily, therefore allowing the contents of the
bag to fall directly into the mixing drum.
7.
Safety Grill
— Provided for operator safety. This safety
grill is designed to keep hands and solid objects out of
the mixing drum when in use. This grill should be closed
at all times when mixer is in use.
DO NOT
remove the
grill or grill opening bar. Keep the grill clean by washing
it down daily.
8.
Pivot Point/Zerk Fitting
— There is a zerk grease
fitting on each end of the mixing drum. These fittings
lubricate the dumping mechanism. Lubricate both
fittings at least twice a week.
9.
Mixing Drum
— Drum capacity is 12 cu. ft (340 liters).
Mixing materials such as mortar and plaster are to be
placed into this drum for mixing. Always clean drum
after each use.
10.
Swivel Jack Stands
— These jack stands swivel out
to support the mixer.
11.
Forklift Pockets
— When lifting of the mixer is
required, use these fork lift pockets to lift the mixer.
Remember to insert the forks of the forklift a minimum
of 24 inches into the lift pockets.
12.
Adjustable Stabilizer Jack Stands
— Use these jack
stands to adjust the mixer to the desired height.
13.
Hydraulic Oil Filter
— 10 micron hydraulic filter. Filters
out small particles that are harmful to the hydraulic
system.
14.
Charcoal Canister
— A container filled with activated
charcoal that traps gasoline vapors emitted by the
fuel system.A container filled with activated charcoal
that traps gasoline vapors emitted by the fuel system
(gasoline only).
15.
Shaft Seals
— There is a zerk grease fitting at each
end of the mixing drum. These grease fittings lubricate
the paddle shaft seals. Fittings require daily greasing
with lithium-based EP grease.
MIXER COMPONENTS
Go to Discount-Equipment.com
to order your parts
