Multiplex N2-Fusion ND21RS00, Инструкция по установке, эксплуатации и обслуживанию

Страница: 20 / 44

20 Part Number: 9290312 October/22/2018
Operation Section 3
CLEARING ERROR CODE
IIportant
Prime/Clean button LED will blink continuously and unit
will not dispense until the error is cleared.
To clear the error;
1. Press and hold the Prime/Clean button until the LED
around the button turns OFF.
2. Once the error has been cleared, press and release the
Prime/Clean button again to prime the unit.
PRIMING THE SYSTEM
IIportant
Priming is always required during keg change.
1. Press the Prime/Clean button, located in the upper left
corner of the refrigeration cabinet, once to prime the
coffee line. The LED around the button will flash ON
once, then OFF signifying that the Prime function has
been activated.
2. The pump may run for up to twenty (20) seconds while
priming.
IIportant
If priming fails to complete the system will go into an
error state and the Prime/Clean button LED will blink
continuously until the error is cleared.
NOTE: If error occurs See “Clearing Error Code” on page 20
3. Once the system is primed it is ready to pour drinks.
4. Close cabinet door and unit is ready for use.
TAPS & NOZZLES
For best performance do not allow both taps to remain fully
opened for extended periods of time.
TAP #1
Surface
TAP #2
IIportant
TAP #2 Contains an o-ring,
diffuser disc, and diffuser.
• Tap 1 - Regular Coffee
• Tap 2 - Nitrogenated Coffee
IIportant
Coffee on tap 2 will not be nitrogenated properly if the
correct nozzle with diffuser is not installed.
“How to Remove Nozzles” on page 26 & “How to Install
Nozzles” on page 26
Flow Control & Locking Collar
DO NOT adjust the flow control, it is set at the factory.
The locking collar keeps the tap tightened to the tower. A
special tool is required for proper adjustment.
Flow
Control
Locking
Collar