multilaneinc.com
3.3
LED Indicators
The ML4062-CNT-Gen2 includes on-board LEDs, for quick debugging and monitoring purposes.
LEDs are summarized below:
LED D3 indicates whether a USB cable is plugged or not.
LEDs D1 and D2, colored green and red, respectively, are used for diagnostic purposes:
If D1 is on: USB is locked and device is recognized by the USB driver
If D2 is on: USB is not connected or USB driver is not found
If both are off: board is not powered correctly or firmware is corrupted
If both are blinking: the board is in Bootloader mode
3.4
Low Speed Signals
The low speed signals circuit shown below shows the connection of these signals to the
microcontroller and the pin header connector, for one of the modules ports, the others are
similar.
Figure 1: Low Speed Signals Diagram
4.
ML4062-CNT-Gen2 Software
The ML4062-CNT-Gen2 is accessible and controlled through application software. This software
provides a user-friendly interface to operate the board and access all its features. The
communication between the ML4062-CNT-Gen2 board and the software is established through
USB connection.
4.1
USB Driver
In order to be able to communicate with the board, user needs to install the USB driver of the
ML4062-CNT-Gen2. This is available on the website under the following link (USB Driver icon):
https://multilaneinc.com/products/ml4062-cnt/
