Multikomplex SIRIUS H200, Инструкция по установке, использованию и обслуживанию, Страница: 23 / 25

23
An accurate maintenance guarantees good fun-
ctioning and long-lasting performance. Special
care needs to be taken with the grease filter:
to access the filter, proceed as described in the
PANEL OPENING chapter.
Remove the grease filter, using the special handle
(fig.12).
To refit the grease filter after cleaning, carry out
the same operation in reverse order.
To remove the carbon filter, if fitted, follow the
same steps as for the grease filter.
The carbon filter is located immediately above
the grease filter.
Tepid water and neutral detergents are recom-
mended to clean the appliance, while abrasive
products should be avoided.
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or a simi-
larly qualified person in order to avoid a hazard.
Replacement of the LED bar:
Using an appropriate tool, remove the LED bar
from its seat (refer to Fig. 10), disconnect it elec-
tro nically throught the appropriate connector
then re place it with a LED bar with same cha-
racteristics.
* Replacement of the LED bar GLASS PANEL
To remove the led bar , it is recommended to re
move the steel bar as shown in Fig. 11.
Replace the led bar with one of the same cha
racteristics.
Refit the steel bar.
MAINTENANCE
23