Operate the radio
·
Install Battery:
remove the back cover of the transmitter, connect the battery inside to the
power interface correctly, and install the back cover.
·
Power On:
Long press the power button for about 3 seconds, then pull the throttle to the
lowest position, release the button after the radio vibrates twice, and the power indicator
turns from green to blue, indicating that the radio is turned on.
·
Binding:
1. First press and hold the bind of the receiver, and then power on the aircraft (the
receiver's traffic light is always on at this time)
2. After the remote control is turned on, short press the Bind button on the back of the remote
control, the power indicator will be red
The color and blue flash alternately and enter the linking state for about 10 seconds.
3. If the receiver flashes red, it means the linking is successful
4. After successful linking, the aircraft can be used again after power on
If it is unsuccessful, repeat the above actions and link again. When the throttle is hit to the
lowest level, toggle switch A to unlock, and the motor starts to rotate.
·
Power Off:
press and hold the power button for about 5 seconds, release the button after
the transmitter vibrates, and the power indicator light turns off, transmitter is turned off.
·
Charge:
the power indicator light flashes blue slowly and vibrates when the battery
approaches the low voltage limit. it need to be stopped immediately. Connect the USB cable
to the power supply, and the power LED will show
·
red when charging;
the power LED turns off after the charging process is done.
LED Status
Reason
Solution
Red Solid
The throttle stick or switches
are not in the lowest
Lower throttle and switches
to the lowest position. Turn
to blue then.
Green Solid
The system is loading.
Wait for the system load
completes
Blue Flash Slow
The battery reaches the low
voltage limit
Charging the batteries
Содержание NVISION Junior Racer RTF
Страница 1: ...Junior Racer RTF Quick start manual...
