Page <5>
V1.0
20/04/22
Newark.com/multicomp-pro
Farnell.com/multicomp-pro
sg.element14.com/b/multicomp-pro
8.Temperature locking function:
Temperature locking function on and off:
1) Turning the rotary control to adjust the temperature to be set.
2) Long press the function key till
is displayed.
3) Now LED segment displays
or
4) Turn the control to set the locking function to be
or
5) Press the function key or wait for 10s to automatically save to complete the setting.
6) When the temperature is locked, adjusting the control does not change the setting temperature, it will display
for 1
second to show that the current temperature is locked.
9.Temperature calibration
1) Adjust the set temperature to 350°C (662°F) byr otary control and wait for 2 minutes to stabilize the temperature.
2) Use a thermometer to measure the temperature of the soldering iron tip.
3) Use a cross screwdriver to adjust the calibration hole to make the displayed temperature value equal to the measured
value. For example, if the measured value is 345°C, adjust calibration hole to reduce display temperature 350 to 345,
make the display temperature match the measured value.
4) Press the function key to complete calibration.
Maintenance
In order to make this product durable, please maintain it regularly. The lifespan of this product depends on the
used temperature, quality of solder wire and soldering paste, frequency of use etc. Please repair and maintain
it according to specific use conditions.
Warning
Please pay close attention when the soldering station is in use at high temperature, turn off the
power and unplug the power cord after use.
Soldering iron tip maintenance
1. Set the temperature to 250°C (480°F) .
2. After the temperature is stable, clean the soldering iron tip with a brass wool and check its condition.
3. If black oxide is attached to it, please apply new solder (including flux) and wipe it repeatedly with a brass wool until it’s
clean, then apply some new solder.
4. If the soldering iron tip has been damaged, misshaped or worn out, please replace it with a new one.
Troubleshooting Guide
Warning
When checking or replacing parts, be sure to pull out the power plug to prevent electric shock
● If the power cable is damage, it must be sent to the manufacturer, agency store or maintenance
personnel with the same qualification for repair to avoid accidents
