multicomp pro MP740074, Быстрый старт

Страница: 2 / 4

2
IMPORTANT SAFETY INFORMATION
Please read these instructions carefully before use and retain for future reference.
WHAT’S INCLUDED?
OPERATION
• Desoldering Gun
• User Manual
• Always turn off the mains supply to the soldering station when connecting or
disconnecting soldering tools to avoid damaging the station.
• Allow tools to fully cool before disconnecting from the soldering station and putting
into storage.
• Connect the power cable to the soldering station channel power outlet socket.
• Connect the vacuum pipe to the soldering station vacuum connector.
• Adjust the tool tip temperature using the control on the soldering station.
• Touch the tip to the solder point you wish to remove and when the solder melts
squeeze the trigger on the gun to vacuum the solder off the PCB.
• When using electrical appliances basic safety precautions should always be
followed.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Children shall not play with the appliance. Cleaning and user maintenance shall
not be made by children unless they are older than 8 and supervised.
• Ensure that the soldering iron supply cord is kept away from heat or sharp edges
that could cause damage.
• If the soldering iron supply cord is damaged, it must be replaced by a qualified
engineer in order to avoid injury or a hazard.
• Ensure there is sufficient space and ventilation around the appliance to allow the
escape of heat and/or fumes.
• Do not expose to rain or moisture.
• Never place the product or part of it in water, or operate if your hands are wet.
• Soldering work must be conducted on a stable, non-combustible surface.
• Do not touch any metallic parts near the soldering tip.
WARNING: This tool must be placed on it’s stand when not in use.
• The iron must not be left unattended while it is powered on.
• Do not use the appliance for any purpose other than that for which it is designed.
• Do not use abrasives on the tip to remove oxide, only wipe the tip on a cleaning
sponge or wire pad.
MAINTENANCE
Removing solder waste:
The collector tube must be emptied of solder waste as required or the efficiency of
operation will be impaired.